Tone.AutoPanner↳ EXTENDS Tone.Effect
Tone.AutoPanner is a Tone.Panner with an LFO connected to the pan amount. More on using autopanners here.
CONSTRUCTORnew Tone.AutoPanner ( [
.depth↝ NormalRange #
The amount of panning between left and right. 0 = always center. 1 = full range between left and right.
.channelInterpretation↝ String READONLY #
channelInterpretation determines how individual channels will be treated when up-mixing and down-mixing connections to any inputs to the node. The default value is “speakers”.
.context↝ Tone.Context READONLY #
Get the audio context belonging to this instance.
.numberOfInputs↝ Number READONLY #
The number of inputs feeding into the AudioNode. For source nodes, this will be 0.
.numberOfOutputs↝ Number READONLY #
The number of outputs coming out of the AudioNode.
.channelCount↝ Number READONLY #
channelCount is the number of channels used when up-mixing and down-mixing connections to any inputs to the node. The default value is 2 except for specific nodes where its value is specially determined.
.channelCountMode↝ String READONLY #
channelCountMode determines how channels will be counted when up-mixing and down-mixing connections to any inputs to the node. The default value is “max”. This attribute has no effect for nodes with no inputs.
.wet↝ NormalRange #
The wet control is how much of the effected will pass through to the output. 1 = 100% effected signal, 0 = 100% dry signal.
.start ( )#
Start the effect.
.stop ( )#
Stop the effect.
.sync ( )#
Delay time before starting the effect after the Transport has started.
Sync the panner to the transport.
.disconnect ( )#
Either the output index to disconnect if the output is an array, or the node to disconnect from.
disconnect the output
.toMaster ( )#
Connect ‘this’ to the master output. Shorthand for this.connect(Tone.Master)
.connect ( )#
optionally which output to connect from
optionally which input to connect to
connect the output of a ToneNode to an AudioParam, AudioNode, or ToneNode