Tone.PitchShift↳ EXTENDS Tone.FeedbackEffect
Tone.PitchShift does near-realtime pitch shifting to the incoming signal. The effect is achieved by speeding up or slowing down the delayTime of a DelayNode using a sawtooth wave. Algorithm found in this pdf. Additional reference by Miller Pucket.
CONSTRUCTORnew Tone.PitchShift ( [
The interval to transpose the incoming signal by.
.windowSize↝ Time #
The window size corresponds roughly to the sample length in a looping sampler. Smaller values are desirable for a less noticeable delay time of the pitch shifted signal, but larger values will result in smoother pitch shifting for larger intervals. A nominal range of 0.03 to 0.1 is recommended.
.pitch↝ Interval #
Repitch the incoming signal by some interval (measured in semi-tones).
.context↝ Tone.Context READONLY #
Get the audio context belonging to this instance.
.numberOfInputs↝ Number READONLY #
The number of inputs feeding into the AudioNode. For source nodes, this will be 0.
.numberOfOutputs↝ Number READONLY #
The number of outputs coming out of the AudioNode.
.channelCount↝ Number READONLY #
channelCount is the number of channels used when up-mixing and down-mixing connections to any inputs to the node. The default value is 2 except for specific nodes where its value is specially determined.
.channelCountMode↝ String READONLY #
channelCountMode determines how channels will be counted when up-mixing and down-mixing connections to any inputs to the node. The default value is “max”. This attribute has no effect for nodes with no inputs.
.channelInterpretation↝ String READONLY #
channelInterpretation determines how individual channels will be treated when up-mixing and down-mixing connections to any inputs to the node. The default value is “speakers”.
.wet↝ NormalRange #
The wet control is how much of the effected will pass through to the output. 1 = 100% effected signal, 0 = 100% dry signal.
.feedback↝ NormalRange #
The amount of signal which is fed back into the effect input.
.connect ( )#
optionally which output to connect from
optionally which input to connect to
connect the output of a ToneNode to an AudioParam, AudioNode, or ToneNode
.disconnect ( )#
Either the output index to disconnect if the output is an array, or the node to disconnect from.
disconnect the output